While the site is going through updates you may notice slow downs in page loads and other glitches through out the pages. If something seems to not be working correctly wait a few minutes and try again. If the error persists message taurarious using the forum or email him at Taurarious@threepercenters.org so that he knows an issue exists.

Are cold hammer forged barrels worth it?

What benefits does a CHF barrel have over a standard chrome lined Ar15 barrel? I tried google but most people go back and forth and dont really explain the actual benefits of chf barrels.

Comments

  • When it comes to FN FAL's I prefer a hammer forged barrel though.....

    http://www.norma-usa.com/index.php/2012-01-09-02-10-41/42-what-are-the-differences-between-cold-hammered-button-rifled-and-cut-rifled-barrels

    What are the differences between cold-hammered, button-rifled and cut-rifled barrels?

    Print
    Email

    The raw material for a hammered barrel is a relatively thick steel blank, which is worked by drilling, grinding and polishing. It is then placed over a mandrel and shaped by hammering. The shape of the mandrel corresponds to a reverse image of the barrel including grooves and lands. Hammered blanks are often polished afterwards. Finally, the chamber for certain calibres is also worked by hammering. It only takes a few minutes to produce a barrel in this way but the machinery is very expensive, which is why only larger manufacturers use this method.

    Button-rifled barrels are also made by drilling, grinding and polishing. The rifling pattern is then pressed into the barrel with a tool called a button. Afterwards the barrel is polished with a lead rod and grinding paste. This method is frequently used by smaller manufacturers, as it does not require such expensive tooling.

    The oldest method of rifling barrels is by cutting. The first steps are the same as for the other two methods described above. A tool fitted on the end of a rod then moves through the barrel, forming the grooves by gradually cutting deeper and deeper on each pass. This method is very time consuming.

    Good barrels can be made with all these methods. Button or cut-rifled barrels are generally the best.
  • good stuff thanks PM.
Sign In or Register to comment.